Selecting Which Tests To Run - Quantum Data 980 User Manual

980 User Guide – HDMI Compliance Tests
Rev. B29
3.4

Selecting which tests to run

Use the following procedures to select the tests to run. There are multiple tabs which correspond to each section in
the CTS.
To select the tests to run:
1. Select the Test Selection panel as shown below.
2. If you have an existing Test Selection option file saved you can recall that for use in your testing. Simply click
on the Open activation button.
A dialog box will appear as follows. Simply select the file and click on the OK activation button.
3. Complete the items in the Protocol tab of the Test Selection panel shown below.
Page 33 August 5, 2011