Table of Contents
Advertisement
3
Mechanical installation
WARNING
3.1
Installation of an option module is illustrated in Figure 3-1.
Figure 3-1 Installing an option module
•
Option module slots must be used in the following order: slot 3 (lower), slot 2
(middle) and slot 1 (upper).
•
Orientate the option module above the drive as shown (1) in the first image above.
•
Align and insert the option module tab into the slot and press down until the option
module locks into place.
8
Before installing or removing an option module from any drive, ensure the
AC supply has been disconnected for at least 10 minutes and refer to
section 1 Safety information on page 4. If using a DC bus supply ensure
this is fully discharged before working on any drive or option module.
General installation
1
2
SI-PROFINET RT User Guide
Issue Number: 2
Advertisement
Table of Contents
