Table of Contents
Advertisement
Quick Start Guide
GFK-2941K
2. Hardware Installation
2.1.
Initial Checks
Upon receiving your RX3i equipment, carefully inspect all shipping containers for
damage. If any part of the system is damaged, notify the carrier immediately. The
damaged shipping container should be saved as evidence for inspection by the
carrier.
As the consignee, it is your responsibility to register a claim with the carrier for
damage incurred during shipment. Emerson will fully cooperate with you, however,
should such action be necessary.
After unpacking the RX3i equipment, record all serial numbers. Serial numbers are
required if you should need to contact Customer Care during the warranty period. All
shipping containers and all packing material should be saved should it be necessary
to transport or ship any part of the system.
Verify that all components of the system have been received and that they agree with
your order. If the system received does not agree with your order, contact Customer
Care.
2.2.
Installation Location
This product is intended for use with the RX3i system. Its components are considered
open equipment (having live electrical parts that may be accessible to users) and
must be installed in an ultimate enclosure that is manufactured to provide safety. At
a minimum, the enclosure shall provide a degree of protection against solid objects
as small as 12mm (e.g. fingers). This equates to a NEMA/UL Type 1 enclosure or an
IEC60529 IP20 rating providing at least a pollution degree 2 environment. For details
about installing RX3i rack systems, refer to the PACSystems RX3i System Manual,
GFK-2314.
Hardware Installation
Section 2
Sep 2019
11
Advertisement
Table of Contents
