Program The Terminating Character Suffix; Program The Code Id; Program The Bad Read Message - Newland NLS-FM3051-2X User Manual

h. Program the Terminating Character Suffix
Example: Set the terminating character suffix to 0x0D
1. Scan the Enter Setup barcode.
Scan the Set Terminating Character Suffix barcode from the "Set Terminating Character Suffix"
2.
section in Chapter 6.
Scan the numeric barcodes "0" and "D".
3.
4. Scan the Save barcode.
5. Scan the Exit Setup barcode. (If you still need to program other parameter/feature, skip this step.)
i. Program the Code ID
Example: Set the Code ID of PDF 417 to "p"
Check the hex value of "p" in the ASCII Table. ("p": 70)
1.
2. Scan the Enter Setup barcode.
Scan the Modify PDF417 Code ID barcode from the "Modify Code ID" section in Chapter 6.
3.
Scan the numeric barcodes "7" and "0".
4.
5. Scan the Save barcode.
6. Scan the Exit Setup barcode. (If you still need to program other parameter/feature, skip this step.)
j. Program the Bad Read Message
Example: Set the bad read message to "!ERR"
Check the hex values of "!ERR" in the ASCII Table. ("!ERR": 21, 45, 52, 52)
1.
2. Scan the Enter Setup barcode.
Scan the Set Bad Read Message barcode from the "Bad Read Message" section in Chapter 5.
3.
Scan the numeric barcodes "2", "1", "4", "5", "5", "2", "5" and "2".
4.
5. Scan the Save barcode.
6. Scan the Exit Setup barcode. (If you still need to program other parameter/feature, skip this step.)
163