Table of Contents
Advertisement
CAUTION
•
DO NOT operate the heater in an explosive environment Keep this
appliance away from areas where you have stored gas. or other vapors and
flammable liquids.
•
Before use， verify that no parts are damaged, inspect gas hose.
•
Never modify, this appliance in any way or it will void the warranty.
•
Never use the heater without the reflector shield .
•
Respect minimum clearance from combustibles top 36", sides 24".
. •
Always place heater on a leveled, stable and hard surface.
•
Only use this heater outdoors.
•
Never clean with abrasive, corrosive or flammable cleaners.
•
Do not paint the heater or any of its parts.
•
When fully assembled please perform a leak test, and every time you
disconnect the hose, before lighting up the heater.
•
A leak test must be performed before operating the appliance.
To leak test, use a 50/50 mix of each water and soap in a spray bottle.
•
NEVER LEAK TEST with an open flame or while smoking.
•
The gas cylinder must be closed at all times when not using the heater.
•
Children and adults should be made aware of hot surfaces on the heater.
•
Clothing and other accessories or objects are not to be hung or laid on the heater
or near it to dry.
•
Do not obstruct the ventilation opening (hand hole) on cylinder cover.
•
Installation, maintenance and repair of this heater should always be performed
by a qualified qas technician.
PARTS LIST
1
Base
C onnector
2
Table
3
Pole
4
Gas control
5
Burner assembly unit
6
Reflector
7
igniter
8
Regulator(inside base)
9
guard bar
10
TOOLS AND EQUIPMENT REQUIRED
Screw(M6X30)
X3
Spring Washer(M6)
X3
X4
Bolt(M6X13)
Washer(M8)
X6
X2
Claw Screw(M6X12)
Bolt(M6X8)
X9
wrench , screwdriver.
TOOLS AND ACCESSORIES
X7
Washer(M6)
Nut(M6)
X3
Claw Nut(M8)
X3
Screw(M6X10)
X4
Nut(M6)
X9
Leak test solution: MIX 50/50 water and soap
1 Propane cylinder (not supplied), with QCC 1 valve
5
7
6
5
8
4
3
2
1
Advertisement
Table of Contents
