Leak Testing; Installation - Paramount Fitness KLD7001S Instruction Manual

LEAK TESTING

Gas connections on the appliance are leak tested at the factory prior to shipment. Possible mishandling of the
appliance during the shipment might contribute to product integrity as a whole. A complete gas leakage test
must be performed again at the installation site.
Please follow the procedure below for leakage test.
1. Make a soap solution of one part liquid detergent and one part water. The soap solution can be applied with
a spray bottle, brush or rag. Soap bubbles will appear where the leak is present.
2. Make sure the control tap is in the <<OFF>> position (full disk = • ) on the control panel
3. Turn on the gas supply and check for bubbles on the hoses and connections. If the solution starts to bubble
that means that a leak is present.
to see if it still continues to leak.
5. Never leak test while smoking

INSTALLATION

Important Safety Rules:
This appliance is for OUTDOOR USE ONLY
1. This appliance shall not be installed or used indoors, in buildings, garages or any
other enclosed area
2. DO NOT place articles on or against this appliance
3.
4. Children and adults should be aware to the hazards of high surface temperatures, burns and
clothing ignition
5. Children should be carefully supervised when they are in the area of the appliance
6.
7.
8. DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION
9.
may be required as necessary. It is imperative that control compartments, burners and
circulating air passages of the heater and light be kept clean
Warning
do not smoke
WARNING
while leak testing