Operation - Paramount Fitness KLD7001S Instruction Manual

OPERATION

PREPARATION:
You will need to purchase a propane gas cylinder designed to be
used with the regulator purchased or supplied. For correct operation
of the gas system follow the instructions supplied with the regulator
supplied or purchased. Connect the hose to the hose connector
in the control box.
Warning: Always test the hose for leaks with soapy water at
the end of all connections
WARNING :
• Never use the heater while it is raining, the glass tube would break when it comes in contact with water
• Never splash any liquid onto the glass tube when the heater is working
• The glass tube will be extremely hot when it is working, never try to touch it and keep children away
from the heater
objects or the ground.
• Never use the heater if the glass tube has a crack or chip
LIGHTING INSTRUCTIONS
Check and ensure that an AA battery is inside the ignition
chamber and has power. The anode (+) side of the battery
must face outside.
1. Ensure that the control knob is OFF and slowly open
the gas cylinder valve
2. Press and turn the control knob to LIGHT, Press ignition button
pilot does not light, turn the control knob to the << OFF>>
position and try again from the beginning.
Several attempts may be necessary
4. When the pilot light is lit keep the control knob depressed
(pushed down) for 15 seconds then turn the control
knob to <<LOW>>
5. For maximum heat turn the control knob to <<HIGH>>
6. T OFF>>
-14-
Hose
Connector