Teledyne Falcon4 86M User Manual page 48

Device DeviceTemperatureSelector
Temperature
Selector
FPGA Board FPGABoard
Sensor Board SensorBoard
Sensor Sensor
Device DeviceTemperature
Temperature
Refresh readTemperature
Temperature
Device Voltage DeviceVoltage
User Set Default UserSetDefaultSelector
Selector
Factory Factory
UserSet1 UserSet1
to to
UserSet 4 UserSet4
User Set Selector UserSetSelector
Factory Set Factory
User Set 1 UserSet1
to to
User Set 4 UserSet4
User Set Load UserSetLoad
User Set Save UserSetSave
Device Reset DeviceReset
46  Contents
Select the source where the temperature is
read. (RW)
Read FPGA Board temperature.
Read sensor board temperature.
Read sensor temperature.
Displays the device temperature in degrees
Celsius.
Depending on the host application (e.g.
GUI). This value is a polled value and may
automatically be updated every second.
Otherwise the value will only be updated
upon connection or when the Refresh
Temperature selector is pressed.
Refreshes the temperature reading. (W)
The applied voltage to the image sensor.
(RO)
Selects the camera configuration set to
load and make active on camera power-up
or reset. The camera configuration sets are
stored in camera non-volatile memory.
(RW)
Load factory-calibrated defaults.
Select the user defined configuration
(UserSet1 to UserSet8) as the Power-up
Configuration.
Selects the camera configuration set to
load feature settings from or save current
feature settings to. The Factory set
contains default camera feature settings.
User camera configuration sets contain
features settings previously saved by the
user. (RW)
Select the default camera feature settings
saved by the factory.
Select the User Defined Configuration
space (UserSet1 to UserSet8) to save to or
load from features settings previously
saved by the user.
Loads the camera configuration set
specified by the User Set Selector feature,
to the camera and makes it active. (W)
Saves the current camera configuration to
the user set specified by the User Set
Selector feature. The user sets are located
on the camera in non-volatile memory.
Disabled when flatfieldCorrectionMode =
Calibration or UserSetSelector = Factory.
(W)
Resets the device to its power up state.
(W)
1.00
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Falcon4 86M Cameras