Teledyne Falcon4 86M User Manual page 66

Grey Horizontal GreyHorizontalRamp
Ramp
Grey Vertical Ramp GreyVerticalRamp
Purity Purity
Grey Diagonal GreyDiagonalRamp
Ramp
Static Value Static Value
PRNU PRNU
Test Image Static testImageStaticValue
Value
Summing Mode summingMode
Off Off
Active Active
Summing Count (in summingCount
frame)
Burst Mode summingBurst
Active Active
Off Off
Median Filter medianFilter
Active Active
Off Off
Median Filter medianFilterThreshold
Threshold
64  Contents
Image is filled horizontally with an image that goes
from the darkest possible value to the brightest.
Image is filled vertically with an image that goes from
the darkest possible value to the brightest.
Image is filled with an image that goes from the darkest
possible value to the brightest by 1 DN increment per
frame.
Image is filled horizontally and vertically with an image
that goes from the darkest possible value to the
brightest by 1 DN increment per pixel.
User-specified static value. The value is set using the
testImageStaticValue feature.
This is 2 times the sum of a horizontal test pattern that
repeats every 64 pixels and a vertical test pattern that
repeats every 62 lines plus + testImageStaticValue.
This test pattern can be used to test FPN and PRNU
correction.
Pixel value to use for test image when the
TestImageSelector feature is set to ―Static Value‖.
Read-Write when TestImageSelector is either PRNU,
or StaticValue.
Possible values are: 0 to 4095
Enables camera summing mode.
The camera will output 1 frame at a time.
The camera will sum 2 or more frames and output the
summed image
Specifies the number of frames to sum. Read-Write
when summingMode is Active.
Possible values are: 2 to 8, in increments of 1.
Enables camera summing burst mode. This mode
effects the maximum frame rate (i.e.
AcquistionFrameRate). Read-Write when
summingMode is Active.
When the camera is triggered (either internally or
externally), it will generate a series (summingCount) of
internal triggers at the maximum frame rate. For
example, when the camera is set to a frame rate of 1
Hz in this mode, and the summingCount = 4, the
camera will generate 4 triggers at the maximum frame
rate every second.
The camera to average the specified number of frames
(summingCount) as it receives the internal or external
frame triggers.
Active: The camera will use 3x3 2D median filter
The camera will not use 3x3 2D median filter
Specifies the median filter threshold. If the difference
between the current pixel and median of its neighbor
pixels is greater than this value, the current pixel will be
replaced.
Possible values are 0 to 2048, in increments of 1.
DFNC
Beginner
DFNC
Guru
DFNC
Guru
DFNC
Guru
DFNC
Guru
Falcon4 86M Cameras