Teledyne Falcon4 86M User Manual page 54

H1_Pin11Pos_Pin12Ne
g
H1_Pin3_Pin4
H1_Pin7_Pin8
Line Debouncing Period
Line Inverter
True
False
Line Status
True
False
Output Line Source
Off
Software Controlled
Pulse On: Start of
Exposure
Pulse On: End of
Exposure
Pulse On: Start of
Readout
Pulse On: End of
Readout
Pulse On: GP Input 1
Pulse On: GP Input 2
52  Contents
H1_Pin11Pos_Pin12Neg
H1_Pin3_Pin4
H1_Pin7_Pin8
lineDebouncingPeriod
Line Inverter
True
False
LineStatus
True
False
outputLineSource
Off
SoftwareControlled
PulseOnStartofExposure
PulseOnEndofExposure
PulseOnStartofReadout
PulseOnEndofReadout
PulseOnInput1
Pulse OnInput2
General Purpose Input 2:
Hirose Pin 11 Positive, Pin 12 Negative.
General Purpose Output 1:
Hirose Pin 3, Pin 4.
General Purpose Output 2:
Hirose Pin 7, Pin 8.
Specifies the minimum length of an input line voltage
transition before recognizing a signal transition.
Available when the Line Selector is set to an input.
Each input line stores its own debouncing period.(RW)
Possible values are: 1 to 255 µs.
Controls whether to invert the selected input or output
line signal. (RW)
Invert signal.
Do not invert signal.
Returns the current status of the selected input or
output line. This is a polled feature that requires the
host to poll the camera for the latest value.(RO)
Selected signal is high.
Selected signal is low.
Selects which internal signal or software control
state to output on the selected line. The pulse
is defined by outputLinePulseDelay and
outputLinePulseDuration.(RW)
Note: the Line Mode feature must be set to
Output.
The output line is open.
The value of the output line is determined by
outputLineValue,
outputLineSoftwareLatchControl and / or
outputLineSoftwareCmd.
Generate a pulse when the sensor actually
starts exposing its pixels. (Slight delay after
EXSYNC).
Generate a pulse when the sensor stops
exposing its pixels.
Generate a pulse when the sensor starts
reading its pixels.
Generate a pulse when the sensor stops
reading its pixels.
Generate a pulse when the General Purpose
Input 1 goes active.
Generate a pulse when the General Purpose
Input 2 goes active.
Falcon4 86M Cameras
DFNC
Beginner
Beginner
Beginner
DFNC
Beginner