Teledyne Falcon4 86M User Manual page 51

Frame Rate
Exposure Mode
Timed
Trigger Width
Exposure Time
Gain Selector
All Digital
Digital Red(Bayer
Camera Only)
Digital Blue(bayer
Camera Only)
Digital Green
Blue(BayerCamera Only)
Digital Green Red
Gain
Black Level Selector
Digital Before FFC
Digital After FFC
Background Add
Falcon4 86M Cameras
AcquisitionFrameRate
ExposureMode
Timed
TriggerWidth
ExposureTime
GainSelector
DigitalAll
DigitalRed
DigitalBlue
DigitalGreenBlue
DigitalGreenRed
Gain
BlackLevelSelector
DigitalAll1
DigitalAll2
BackgroundAdd
Specifies the camera internal frame rate, in
Hz. (Read-only when TriggerMode = "On")
1 to x Hz (where x is a calculated maximum)
The maximum value of the frame rate is the
result of a complicated formula and is
dependent on the following features:
Height, summingMode, pixelformat
Note that any user entered value is
automatically adjusted to a valid camera
value.
Sets the operation mode for the camera's
exposure.
The exposure duration time is set using the
Exposure Time feature and the exposure
starts with a LineStart event.
Uses the width of the trigger signal pulse to
control the exposure duration. Use the
Trigger Activation feature to set the polarity of
the trigger.
The Trigger Width setting is active when the
Trigger Mode is On and a signal (e.g. Line 1)
is selected as the trigger source. These
features are found in the I/O Control
category.
Sets the exposure time (in microseconds)
when the Exposure Mode feature is set to
Timed.
Selects which channel's gain is controlled
when adjusting gain features.
Apply a digital gain adjustment to the entire
image.
Green pixels that share same row as blue.
Green pixels that share the same row as red.
Sets the selected gain as an amplification
factor applied to the image. (RW)
Selects which black level (i.e. dark offset) is
controlled when adjusting the black level
feature.(RW)
Global FPN. Apply black level adjustment to
all digital channels or taps, before flat field
correction.
Background Subtract. Apply black level
adjustment to all digital channels or taps,
after flat field correction.
Add a digital value to the image before FFC
(tbc)
Beginner
Beginner
Beginner
Beginner
Beginner
Beginner
Contents  49