TOHATSU MFS 40A Owner's Manual page 69

1. Drain hole
6. Tighten the oil drain screw with
applying oil on the sealing surface of
screw. (Use new oil drain washer)
Oil drain screw specified torque
24N·m (17 ft lb, 2.4 kgf
·
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn
past finger-tight. Have the oil filter
adjusted to the correct torque as soon as
possible with a torque-wrench.
7. Reset the engine in a vertical posi-
tion.
8. Repeat 3 to 7 procedures two or
three times to drain the oil com-
pletely.
9. Remove the top cowl and the oil
filler cap.
10. Fill the engine through filler port
with recommended oil (see char t
below) to the middle of dipstick
mark.
11. Tighten the oil filler cap.
1
ENOF00923-0
m)
·
INSPECTION AND MAINTENANCE
1
3
1. Filler cap
2. Dipstick
3. Filler port
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
10W−40
10W−30
-30 -20 -10 0 10
-22 -4 14 32 50
2
ENOF00924-0
1
ENOF00113-0
2
20 30 40 ˚C
68 86 96 ˚F
ENOF00208-0
69
10