Powering Off - Optoma DLP User Manual

USING THE PROJECTOR
[Select Power Mode]

Powering off

1. Turn off the projector by pressing the "
2. The following message will be displayed:
Power Off
Please press power again
3. Press the "
you press the "
4. The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the On/
Standby LED will fl ash green or fl ash blue. When the On/Standby LED turns solid red, this indicates
the projector has entered standby mode. If you wish to turn the projector back on, you must wait until
the cooling cycle has fi nished and the projector has entered standby mode. When the projector is in
standby mode, simply press the "
5. Disconnect the power lead from the electrical outlet and the projector.
Notee: It is not recommended that the projector is turned on immediately, right after a power off procedure.
button again to confi rm, otherwise the message will disappear after 15 seconds. When
" button for the second time, the projector will shut down.
" button again to turn on the projector.
[Initial Setup Complete]
" button on the projector keypad or the remote control.
19
English