Table of Contents
Advertisement
USING THE PROJECTOR
Powering on / off the projector
Powering on
1.
Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
red.
2.
Turn on the projector by pressing the
3.
A start up screen will display in approximately 10 seconds and the Power LED will be flashing blue.
Note:
The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1.
Turn off the projector by pressing the
2.
The following message will be displayed:
3.
Press the
you press the
4.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the Power
LED will flash blue. When the Power LED turns solid red, this indicates the projector has entered
standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle has
finished and the projector has entered standby mode. When the projector is in standby mode, simply
press the
5.
Disconnect the power lead from the electrical outlet and the projector.
Note:
It is not recommended that the projector is turned on immediately, right after a power off procedure.
button again to confirm, otherwise the message will disappear after 15 seconds. When
button for the second time, the projector will shut down.
button again to turn on the projector.
Power
or
Freeze
L
Page-
Laser
Keystone
-
+
1
4
HDMI
7
User1
Source
button on the projector keypad or remote control.
button on the projector keypad or remote control.
Power Off
Press power key again.
Switch
R
Enter
Page+
Volume
-
+
2
3
Menu
3D
5
6
VGA
Video
8
9
User2
User3
0
Resync
21
English
Advertisement
Table of Contents
