USING THE PROJECTOR
Powering on / off the projector
Powering on
1.
Securely connect the power lead and signal/source cable. When connected, the On/Standby LED will
turn red.
2.
Turn on the projector by pressing the "
3.
A start up screen will display in approximately 10 seconds and the On/Standby LED will be fl ashing
blue.
The fi rst time the projector is turned on, you will be prompted to do the initial setup including selecting the preferred
language, projection orientation, and power mode settings. Once the Complete set screen appears, this indicates
the projector is ready to use.
18
English
or
Enter
Enter
[Select Language]
" button on the projector keypad or the remote control.
[Select Projection Mode]