Table of Contents
Advertisement
USING THE PROJECTOR
Powering on / off the projector
Powering on
1.
Remove the lens cap.
2.
Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
red.
3.
Turn on the projector by pressing the
4.
A start up screen will display in approximately 10 seconds and the Power LED will be flashing blue.
Note:
The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1.
Turn off the projector by pressing the
control.
2.
The following message will be displayed:
3.
Press the
When you press the
4.
The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the Power
LED will flash blue. When the Power turns solid red, this indicates the projector has entered standby
mode. If you wish to turn the projector back on, you must wait until the cooling cycle has finished and
the projector has entered standby mode. When the projector is in standby mode, simply press the
button again to turn on the projector.
5.
Disconnect the power lead from the electrical outlet and the projector.
Note:
It is not recommended that the projector is turned on immediately, right after a power off procedure.
Lens cap
or
button again to confirm, otherwise the message will disappear after 15 seconds.
or
button for the second time, the projector will shut down.
On
or
Geometric
Correction
F1
Mode
ENTER
Info.
Source
Volume
Menu
Format Freeze
VGA
S-Video
1
2
HDBaseT
Video
4
5
BNC
YPbPr
7
8
button on the projector keypad or remote control.
button on the projector keypad or the
Power Off
Press power key again.
Off
PIP/PBP
F2
AV Mute
Re-Sync
F3
F3
D Zoom
Remote
ID
All
HDMI1
HDMI2
3
DVI
HDMI3
6
DisplayPort
3D
9
0
button on the remote
23
English
Advertisement
Table of Contents
