Table of Contents
Advertisement
N
N
ote
ote
Turn on the
projector fi rst and
then select the
signal sources.
Powering the projector on/off
Powering on the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
connected, the Power LED will turn red.
3. Turn on the lamp by pressing "POWER" button either on the
top of the projector or on the remote. The Power LED will
now turn Green.
The startup screen will display in approximately 10 seconds.
The fi rst time you use the projector, you can select your
preferred language after the startup screen displays.
4. Turn on and connect the source that you want to display
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, push
menu button and go to "OPTIONS".
Make sure that the "Source Lock" has been set to "Off".
If you connect multiple sources at the same time, press the
"SOURCE" button on the control panel or direct source keys
on the remote control to switch between inputs.
Installation
Power/Standby
2
1
Lens Cap
13
Advertisement
Table of Contents
