Info Menu; Reset All Menu - Optoma DLP User Manual

USING THE PROJECTOR
by using RS232 command.
‡ Test Pattern: Select the test pattern from Grid (Green), Grid (Magenta), Grid (White), White or disable
this function (None).
‡ Projection Mode: Select the preferred projection between Front, Rear, Front-Ceiling, and
Rear-Ceiling.
‡ HDMI EDID: Select the HDMI EDID type from 2.0 or 1.4.
Notee: If you experience abnormal color issue, please adjust the EDID setting.
‡ HDMI/VGA/USB Disk: Define how the system will react when one of the input sources (HDMI/VGA/
USB flash drive) is connected to the projector.
‡ Notification: Choose "Notification" to display the input switching confirmation message when an
input source is detected.
‡ Source Auto-change: Choose "Source Auto-change" to automatically switch to the currently
detected input source.
‡ None: Choose "None" to manually switch the input source.
‡ High Altitude: When "On" is selected, the fans will spin faster. This feature is useful in high altitude
areas where the air is thin.
‡ 12V Trigger: Use this function to enable or disable the trigger.
‡ On: Choose "On" to enable the trigger.
Off: Choose "Off" to disable the trigger.
‡

Info menu

View the projector information as listed below:
‡ Regulatory
‡ Serial Number
‡ Source
‡ Resolution
‡ Display Mode
‡ Brightness Mode
‡ Power Mode(Standby)
‡ Lamp Hour
‡ Filter Usage Hour
‡ Projector ID
‡ Color Depth
‡ Color Format
‡ FW Version

Reset all menu

Return the factory default settings for all settings.
12V
NC
GND
33
English