Table of Contents
Advertisement
a.
Make sure that the screws on the access panel are in the open position (the screw insert is
parallel to the side of the access panel).
b.
Slide the back of the cover under the blade server bezel, aligning the screws with the slots on
the blade server.
c.
Using a screwdriver or a coin, turn each of the screws away from the middle of the blade
server until it is in the locked position.
Removing a hypervisor key
Use this information to remove a hypervisor key from the blade server.
The following illustration shows the removal of a hypervisor key from the blade server.
To remove the hypervisor key, complete the following steps:
46
BladeCenter HX5 Blade ServerInstallation and User's Guide
Interposer
card
Key
Advertisement
Table of Contents
