Table of Contents
Advertisement
If you are using the BladeCenter HX5 blade server in a virtualized environment, you might need to install a
hypervisor key, depending on the virtualization software that you are using. If you are using a scalable blade
complex that is configured as a single hardware partition, install the hypervisor key in the bottom (left) blade
server in the complex.
If the blade servers in a scalable blade complex are operating independently, you might have to install a
hypervisor key in each blade server. To determine whether you need a hypervisor key, see the
documentation that comes with your virtualization software. For more information about virtualization, see
http://www.ibm.com/itsolutions/virtualization/.
Note: The BladeCenter HX5 supports the option part number 41Y8278, which contains VMWare ESXi 4.0.
When you order a replacement, order 42D0545, which is a blade 2 GB USB key.
The following illustration shows the installation of the hypervisor key.
To install a hypervisor key, complete the following steps:
Step 1.
Before you begin, read "Safety" on page iii and "Installation guidelines" on page 23.
Step 2.
Remove the access panel if you have the standard heat sinks installed.
Note: If you have the tall heat sinks installed, you do not need to remove the access panel.
44
BladeCenter HX5 Blade ServerInstallation and User's Guide
Interposer
card
Key
Advertisement
Table of Contents
