Table of Contents
Advertisement
Installing the scalability tray
Use this information to install the scalability tray on a blade server.
To install the scalability tray, complete the following steps:
Step 1.
Before you begin, read "Safety" on page iii and "Installation guidelines" on page 23.
Step 2.
Carefully lay the blade server on a flat, static-protective surface, with the cover side down.
Step 3.
Align the scalability tray flush with the blade server in the start position. The pins on the scalability
tray should be aligned with the holes in the blade server.
Step 4.
Pressing down firmly on the middle of the tray, slide the scalability tray forward toward the bezel
until there is an audible click each side of the blade server.
Step 5.
Attempt to pull the scalability tray back to ensure that the scalability tray is firmly seated.
Step 6.
Look in the holes on each side of the blade server to ensure that the spring plates are engaged.
.
Chapter 3
Installing optional devices
61
Advertisement
Table of Contents
