Table of Contents
Advertisement
To install an IBM MAX5 expansion blade, complete the following steps.
Power
jumper
Step 1.
Before you begin, read "Safety" on page iii and "Installation guidelines" on page 23.
Step 2.
Remove the cover on the BladeCenter HX5 blade server if one is installed (see "Removing the blade
server cover" on page 25 for instructions).
Step 3.
Locate the power sharing connector on the BladeCenter HX5 blade server and remove the power
sharing cover if one is installed (see "Blade server connectors - BladeCenter HX5" on page 20).
Step 4.
There are two types of access panels available on the BladeCenter HX5 blade server, depending on
whether tall heat sinks are installed in the blade server. Complete the following steps if you are
installing an IBM MAX5 expansion blade on a BladeCenter HX5 blade server that has tall heat
sinks:
1. Remove the operator control panel access panel:
64
BladeCenter HX5 Blade ServerInstallation and User's Guide
IBM MAX5
Blade server
cover release
Blade server
cover release
Upper
ridge
Advertisement
Table of Contents
