Yamaha XG250 Service Manual page 48

1. Front brake hose
2. Right handlebar switch lead
3. Front brake light switch lead
4. Throttle cable (decelerator)
5. Throttle cable (accelerator)
6. Cylinder head side cover 3
7. T-stud
8. Carburetor warmer lead
9. Starter motor lead
10. Rear brake switch lead
11. Battery negative lead
12. Tail/brake light lead
13. Rear turn signal lead
14. Thermo switch lead
15. Rectifier/regulator lead
16. Left hundlebar switch lead
17. Clutch switch lead
18. Clutch cable
A. Route the throttle cable between the front
brake hose and lead.
B. Route the front brake switch lead and
handlebar switch right lead behind the
throttle cable.
C. Fasten the wire harness (2 harnesses)
with a clamp. Cut it off and turn the edge
behind the cross tube.
D. Make sure that the clip end faces to the
front side.
E. Fasten the thermo switch lead, rectifier/
regulator lead and regulator ground lead
with a clamp.
F. Make sure that the clip end faces to the
upper side.
G. Make sure to fasten the wire harness
with the T-stud.
H. Route the cutch cable between the throt-
tle cable (decelerator) and throttle cable
(accelerator).
I. Through the engine hanger hole.
J. Clamp the left handlebar switch lead and
clutch switch lead at the round part of
handlebar.
K. Clamp the right handlebar switch lead
and front brake switch lead at the round
part of the handlebar.
L. Guide the clutch cable, clutch switch
lead, handlebar switch left lead and main
switch lead with a stay.
M. Install the rectifirer/regurator ground lead
horizontally to the body.
N. Turn toward the front of the body.
O. Turn to the ground.
P. The upper part of the body.
2-32
CABLE ROUTING