Epson PP-100II Technical Reference Manual page 96

Item INFORMATION code
Light magenta ink HIKLM000
HIKLM001
Black ink HIKBK000
HIKBK001
Stacker 1 HST1000
HST1001
Stacker 2 HST2000
HST2001
Stacker 3 HST3000
HST3001
HST3002
Disc cover HDC000
Communication HNW000
HNW001
96
Explanation and Remedies
The light magenta ink cartridge has been removed.
Remedy:
Install the light magenta ink cartridge.
The model number of the light magenta ink cartridge is different or the model number cannot
be recognized.
Remedy:
Replace the light magenta ink cartridge with a correct one.
The black ink cartridge has been removed.
Remedy:
Install the black ink cartridge.
The model number of the black ink cartridge is different or the model number cannot be
recognized.
Remedy:
Replace the black ink cartridge with a correct one.
The number of discs in the stacker 1 has exceeded the upper limit.
Remedy:
Remove discs so that the number of discs in the stacker 1 falls within the
limit.
The stacker 1 has not been installed.
Remedy:
Install the stacker 1.
The number of discs in the stacker 2 has exceeded the upper limit.
Remedy:
Remove discs so that the number of discs in the stacker 2 falls within the
limit.
The stacker 2 has not been installed.
Remedy:
Install the stacker 2.
The number of discs in the stacker 3 has exceeded the upper limit.
Remedy:
Remove discs so that the number of discs in the stacker 3 falls within the
limit.
Stacker 3 is set for the output stacker in standard mode, external output mode, and error rate
measurement mode. However, the stacker 3 is not installed. Alternatively, the stacker 3 is not
installed in batch mode.
Remedy:
Install stacker 3.
Stacker 4 is set for the output stacker in standard mode and external output mode. However,
the stacker 3 is installed instead.
Remedy:
[PP-100II / PP-100 / PP-100N / PP-100AP]
Remove stacker 3.
The disc cover is open.
Remedy:
Close the disc cover
Either one of the following communication errors occur.

Communication with Discproducer is disabled.

The filter driver has not been attached.
Remedy:
(Other than PP-100N)
(1) Check the power supply of the Discproducer.
(2) Check if the USB cable is securely connected.
(3) Connect the publishing machine, and turn on the power.
[For PP-100N]
(1) Check the power supply of the Discproducer.
(2) Check if the network cable is securely connected.
A non-supported version error has occurred, and any of the following has been detected.
(1) Firmware version of the auto loader is not supported.
(2) Firmware version of the drive 1 is different from the supported version.
(3) Firmware version of the drive 2 is different from the supported version.
(3) Firmware version of the printer is not supported.
Remedy:
Upgrade the firmware of the concerning device.