Epson PP-100II Technical Reference Manual page 92

Td bridge
Hide thumbs Also See for PP-100II:
Table of Contents

Advertisement

Job status
Job handling
Accepted jobs
Pause
Automatic recover
92
Error code
STP002
Consecutive errors regarding the error rate above threshold level have occurred and the number of
continuous error rate measurement of Total Disc Setup has exceeded.
Remedy:
(1) Check the blank discs in the source stacker.
(2) Resume or cancel the paused job using EPSON Total Disc Monitor.
When the error still occurs, please contact the store where you purchased Discproducer or our
customer service.
RTN000
No disc is set in the source stacker specified for the job.
Remedy:
Set blank discs in the source stacker.
RTN001
The output stacker specified for the job has become full.
Remedy:
Remove the discs from the output stacker.
RTN002
The disc cover is opening.
Remedy:
Close the disc cover.
RTN003
The ink cartridge cover is open.
Remedy:
Close the ink cartridge cover.
RTN004
The specified label print cannot be made because the ink level is low (the cartridge needs to be
replaced).
Remedy:
Replace the ink cartridge(s) with a new one(s).
RTN005
No ink cartridge is detected.
Remedy:
Install the ink cartridges.
RTN006
The job cannot be made because the stacker has been removed.
Remedy:
Install the stacker.
RTN007
The stacker 3 installation status does not match with the specified publishing mode.
Remedy:
Remove the stacker 3 in Standard or External Output mode.
Install the stacker 3 in Batch mode.
RTN008
The job cannot be made because the stacker 4 is open.
Remedy:
Close the stacker 4.
RTN009
Multiple discs have been transferred to the drive.
Remedy:
(1) Open the disc cover.
(2) Remove the disc from the drive tray, and close the disc cover.
RTN010
Multiple discs have been transferred to the printer.
Remedy:
(1) Open the disc cover.
(2) Remove the disc from the drive tray, and close the disc cover.
RTN011
Cannot recognize the ink cartridge.
Remedy:
Correctly install the ink cartridge.
RTN012
Picking up a disc from the source stacker is failed.
Remedy:
Separate any sticky discs in the source stacker from each other.
Explanation and Remedies

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pp-100Pp-100apPp-50bdPp-7050bdPp-100n

Table of Contents