Connection; Soft Starter Connection - Danfoss VLT Compact Starter MCD 201 Installation Manual

Connection

4 Connection

4.1 Soft Starter Connection

The EtherNet/IP Module is powered from the soft starter.
®
VLT Compact Starter MCD 201/MCD 202
4 4
For the EtherNet/IP Module to accept fieldbus commands,
fit a link across terminals A1–N2 on the soft starter.
®
VLT Soft Starter MCD 500
If the MCD 500 has to be operated in remote mode, input
links are required across terminals 17 and 25 to terminal
18. In hand-on mode, links are not required.
EtherNet/IP Module Connections
A1
N2
3
1
2
3
Table 4.1 Connection Diagrams
8
EtherNet/IP Module
MCD 201/202
1
2
A1, N2: Stop input
EtherNet/IP Module
RJ45 Ethernet ports
Danfoss A/S © 05/2017 All rights reserved.
NOTICE
FOR MCD 500 ONLY
Control via the fieldbus communication network is
always enabled in local control mode and can be
enabled or disabled in remote control mode (parameter
3-2 Comms in Remote). See the VLT
Operating Guide for parameter details.
MCD 500
1
17
18
25
2
3
1 (Auto-on mode)
17, 18: Stop input
25, 18: Reset input
2 EtherNet/IP Module
3 RJ45 Ethernet ports
®
Soft Starter MCD 500
MG17M202