Parallel Port Lpt1; Lpt1 Connector - Lippert 702-0008-10 Technical Manual

3.12 Parallel Port LPT1

The parallel port is located on an IDC26 header. An adapter cable with a standard DSUB-25 female
connector is available.
The parallel port is programmable in BIOS.
Entering Motherboard Device Configuration
configuration of LPT1 is accessible.
LPT1 Parameter
Base Address

LPT1 Connector

Connector type IDC26 pin header 2.54 mm
TME-104-CLR-LX800-R1V3.doc
Disabled, 0x378
0x3BC and 0x278 are not recommended, because of a possible
conflict with the PCI to ISA Bridge
Mode Compatible, PS/2 Bi-directional, EPP 1.7, EPP 1.9
IRQ Disabled, IRQ 5, IRQ 7, IRQ 9, IRQ 10, IRQ 11
DMA None, Channel 1, Channel 3
Pin Signal
1 Strobe
3 Data0
5 Data1
7 Data2
9 Data3
11 Data4
13 Data5
15 Data6
17 Data7
19 ACK
21 Busy
23 Paper End
25 Select
Rev. 1.3
Serial and Parallel Device Configurations,
Possible Settings
Pin Signal
2 Auto LF
4 Error
6 Init
8 Select In
10 GND
12 GND
14 GND
16 GND
18 GND
20 GND
22 GND
24 GND
26 +5V Standby
27(53)