Display Voltage Jumpers; Compact Flash Socket - Lippert 702-0008-10 Technical Manual

Display Voltage Jumpers

Jumper LVDS and Backlight
Connector type IDC6 jumper 2.00 mm.
Use a 2 mm jumper between 1-3 or 3-5 to select the backlight voltage.
Use a 2 mm jumper between 2-4 or 4-6 to select the display voltage.
Note

3.4 Compact Flash Socket

On the bottom side of the board a compact flash socket is located that allows the use of compact
flash cards instead of a hard disk. This socket is connected to the chipset's EIDE port. As default it is
defined as Master. Master/Slave selection can be done in BIOS.
Compact flash cards are available as solid-state disks up to several Gbytes.
With the supported UDMA-4 mode and the latest CF cards there are data rates up to 40MByte/s
possible.
TME-104-CLR-LX800-R1V3.doc
Pin Signal
1 +12 volts
3 Backlight voltage
5 + 5 volts
default jumper setting
Jumper
Power supply
Jumper
Power supply
An arrow marks Pin 1
Rev. 1.3
Pin
2
4 Display voltage
6 +3.3 volts
Backlight
1-3
+12V
LVDS
2-4
+5V
Signal
+5 volts
3-5
+5V
4-6
+3.3V
18(53)