Table of Contents
Advertisement
2.4 Hardware Setup
Caution
Caution
Use the cable set provided by LiPPERT to connect the Cool LiteRunner-LX800 to a VGA monitor.
Connect either PS/2 or USB keyboard and mouse, respectively. Use the 44-wire cable to connect the
harddisk. Make sure that the pins match their counterparts correctly and are not twisted! If you plan
to use additional other peripherals, now is the time to connect them, too.
Connect a 5 volt, min. 1 amps power supply to the power connector and switch the power on.
The display shows the BIOS messages. If you want to change the standard BIOS settings, press the
<F1> key to enter the BIOS menu. See chapter 4.1 for setup details.
If you need to load the BIOS default values, they can be automatically loaded at boot time. See
chapter 4.1 about how to do it.
The Cool LiteRunner-LX800 boots from CD drive, Compact Flash, USB floppy, USB stick, or harddisk.
Provided that any of these is connected and contains a valid operating system image, the display
then shows the boot screen of your operating system.
The Cool LiteRunner-LX800 does not need any cooling measures, neither at standard environment
temperatures from 0 °C ... +60 °C nor in the extended range of -40 °C ... +85 °C.
TME-104-CLR-LX800-R1V3.doc
Be sure to observe the EMC security measures. Make sure you are
always at the same potential as the module.
Never connect or disconnect peripherals like HDD-, PCI- and ISA-
devices while the board's power supply is connected and switched on!
Note The 1 amps value is the minimum you should have for the standard
peripherals mentioned. If you want to use more and/or others, please plan
your power budget first! The system will not work if there is not enough
supply current for all your devices.
Rev. 1.3
11(53)
Advertisement
Table of Contents
