Table of Contents
Advertisement
Display Voltage Jumpers
Jumper LVDS and Backlight
Connector type: IDC6, 2.00 mm.
Use a 2 mm jumper between 1-3 or 3-5 to select the backlight voltage.
Use a 2 mm jumper between 2-4 or 4-6 to select the display voltage.
Note
3.4 EIDE Solid State Drive
On the top side of the board, the SSD is mounted. It can be used instead of a hard disk. Per default,
it is defined as master but that can be changed in BIOS.
The SSD, manufactured by SST, is built as a flash storage organized of Single Level Cells (SLC). It
can be erased over 100.000 times without losing capacity. The wear-leveling feature can increase
that number, depending on the allocation of the disk space.
Product features:
Read Bandwidth
Write Bandwidth
Access time
PATA Compatibility
Power Control
NAND Management
TME-104P-CSR-LX800-R1V5.doc
Pin
Signal
1
+12 volts
3
Backlight voltage
5
+ 5 volts
default jumper setting
Backlight
Jumper
Power supply
LVDS
Jumper
Power supply
An arrow on the PCB marks Pin 1
30 Mbytes/s
10 Mbytes/s
0.2 ms
ATA-5; PIO 0-4; DMA 0-2; UDMA 0-4
Automatic power down during wait periods
Automatic sleep mode during host inactivity
Active wear-leveling algorithm
Pin
2
+5 volts
4
Display voltage
6
+3.3 volts
1-3
+12V
2-4
+5V
Rev 1.5
Signal
3-5
+5V
4-6
+3.3V
16 (44)
Advertisement
Table of Contents
