Hardware Installation; Adapter Cable Set; Bios - Lippert PC/104-Plus Technical Manual

Technical Manual PC/104-Plus "Cool RoadRunner II" Version 1.16

2 Hardware installation

The "Cool RoadRunner II" is delivered with a correct jumper setting for proper operation.
The customer must not change the default jumper settings. Improper jumper settings will
cause system instability or system hang-ups.

2.1 Adapter cable set

With the optional available cable set standard PC devices can be easily connected to the
board. The adapter cable set comprises the following items:
adapter cable 3.5'' power supply connector female to 5.25'' power supply connector
-
male for supplying the board with a standard PC power supply
two adapter cables IDC10 female to DB9 male for serial port 1 and 2
-
adapter cable IDC26 female to DB25 female for parallel port
-
adapter cable IDC10 female to DB9 female plus adapter to SUB-D 15p. female for
-
standard VGA monitors
adapter cable IDC44 / 2mm female to IDC44 / 2mm female to connect 2.5'' EIDE hard
-
disks
flat foil cable 26p. plus PCB adapter to 34p. female 2 row 2.54mm grid
-
The flat foil cable must be inserted in the FFC connector with the blank side on the top. Be
careful not to damage the little safety lever at the floppy connector.

2.2 BIOS

The "Cool RoadRunner II" is delivered with a standard PC BIOS. By default all setup set-
tings are done to have a "ready to run" system, even without a BIOS setup backup battery.
If the user wants to change some settings, pressing the <DEL> key on power up can ac-
cess the setup. The BIOS is located in a flash prom and can be easily updated on board
with software under DOS.
© LIPPERT Automationstechnik GmbH • Hans-Thoma-Str. 11 • 68163 Mannheim • Tel: 0621/43214-0 • Fax: 0621/43214-30
Warning!
The board must not be connected or disconnected to
PC/104 bus or PC/104Plus bus with power supply
switched ON!
April 2004 Page 24 of 42