Epever ET4415BND User Manual page 28

to save or press
adjusted and save operated successfully.
NOTE：The log after the current time will be erased when the clock have be
adjusted.

Device Parameter
There are 2 interfaces about device parameter as shown blew:
Press to enter the Device Parameter interface when the inverse cursor
point to Device Para item. Press
You should input the user password (see above) before setting the
parameters.
The first interface shows the 4-digit controller's ID in networking and keeps the
ID number unique in the networking or PC software or other device(s) couldn't
search it.
nd
The 2 interface shows the backlight time. The range is from 1 to 90 seconds
(60seconds default). ―–‖ means that the backlight is never off. The interval log
is from 1 to 30 minutes (10minutes default).

Control Parameter
Press OK to enter the Device Parameter interface when the inverse cursor
point to Control Para item. Press
for ‗Control Parameter' as shown below.
button to cancel. ―Save success!‖ will be promoted if
Input Password
000000
Local ID
T03-0001
Save Cancel
Backlight Time
60 s
Storage Interval
10min
button to exit.
button to exit. There are 9 interfaces
24
Save success!