1.Major feature of controller (Note: connect the components as the 1-6) Connect with the battery #1 Connect with the battery #2 Connect with the PV. Remote temp. sensor A connection point for RTS(option) to remotely monitor battery temperature Local temp. sensor Measures ambient temperature.
Remote meter connection A communication port for the remote meter Note: where is no RTS, the controller calculate the data which got from the local temp. sensor. The controller will come to RTS automatically when the RTS was connected. 2.Setting mode Three leds flashing, each LED express different specifications, choose the LED first according to the following information, and then press the switch for 5 seconds until the number flashing, choose one number as you need,...
90%(pre-set) Note: in the normal charging status, the controller will divide the charging as the setting. While battery #1 is fully charged, more charge current will be diverted to battery #2, and return to the setting charging automatically when the battery #1 is in low voltage. When the controller detects there is only battery #1, all the charging will go to the battery #1 automatically.
4.Technical information Model EPIPDB-COM-10 EPIPDB-COM-20 12/24VDC Auto Nominal system voltage Rated charge current Sealed / Gel / Flooded Battery Type Equalize charging voltage Sealed:14.6V/ Gel:No/ Flooded: 14.8V Boost charging voltage Sealed:14.4V/ Gel:14.2V/ Flooded:14.6V Float charging voltage Sealed / Gel / Flooded:13.8V Maximum solar voltage 30V(12V System)/55V(24V System)...
Need help?
Do you have a question about the EPIPDB-COM-10 and is the answer not in the manual?
Questions and answers