Honeywell INNCOM e7 User Manual page 2

Important Safety Information and Installation
Precautions
Read all instructions
Failure to follow all instructions may result in equipment damage or a hazardous condition. Read all instructions
carefully before installing equipment.
Local codes and practices
Always install equipment in accordance with the National Electric Code and in a manner acceptable to the local
authority having jurisdiction.
Electrostatic sensitivity
This product and its components may be susceptible to electrostatic discharge (ESD). Use appropriate ESD
grounding techniques while handling the product. When possible, always handle the product by its non-electrical
components.
High voltage safety test
Experienced electricians, at first contact, always assume that hazardous voltages may exist in any wiring system. A
safety check using a known, reliable voltage measurement or detection device should be made immediately before
starting work and when work resumes.
Lightning and high-voltage danger
Most electrical injuries involving low-voltage wiring result from sudden, unexpected high voltages on normally low-
!
voltage wiring. Low-voltage wiring can carry hazardous high voltages under unsafe conditions. Never install or
connect wiring or equipment during electrical storms. Improperly protected wiring can carry a fatal lightning surge for
many miles. All outdoor wiring must be equipped with properly grounded and listed signal circuit protectors, which
must be installed in compliance with local, applicable codes. Never install wiring or equipment while standing in
water.
Wiring and equipment separations
All wiring and controllers must be installed to minimize the possibility of accidental contact with other potentially
hazardous and disruptive power and lighting wiring. Never place 24VAC or communications wiring near other bare
power wires, lightning rods, antennas, transformers, or steam or hot water pipes. Never place wire in any conduit,
box, channel, duct or other enclosure containing power or lighting circuits of any type. Always provide adequate
separation of communications wiring and other electrical wiring according to code. Keep wiring and controllers at
least six feet from large inductive loads (power distribution panels, lighting ballasts, motors, etc.). Failure to follow
these guidelines can introduce electrical interference and cause the system to operate erratically.
Warning
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his own expense.
By using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your
use, or modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from
and against any liability, cost, or damages, including attorneys' fees, arising out of, or resulting from, any
modification to the literature by you.
The material in this document is for information purposes only. The content and the product it describes are subject
to change without notice. Honeywell makes no representations or warranties with respect to this document. In no
event shall Honeywell be liable for technical or editorial omissions or mistakes in this document, nor shall it be liable
for any damages, direct or incidental, arising out of or related to the use of this document. No part of this document
may be reproduced in any form or by any means without prior written permission from Honeywell.
Copyright © 2017 by Honeywell International, Inc. All Rights Reserved.
Honeywell | 277 West Main Street | Niantic, CT 06357 | Phone: 1.860-739-4468 | www.INNCOM.com
36-00013—02