Cisco ASA 5550 Series Getting Started Manual page 32

Connecting Interface Cables
c.
Figure 4-3
1
Connect to copper Ethernet ports to be used for network connections. Copper
Step 5
Ethernet ports are available both in Slot 0 and Slot 1.
Note
a.
Cisco ASA 5550 Getting Started Guide
4-4
Connect the other end of the cable, the DB-9 connector, to the serial port on
your computer.
Connecting to the AUX Port
FLASH
1
2
RJ-45 AUX port
You must use a port in Slot 0 for the inside interface, and a port in Slot 1
for the outside interface.
Connect one end of an Ethernet cable to a copper Ethernet port, as shown in
Figure 4-4 and Figure
Chapter 4 Connecting Cables to Network Interfaces
2 RJ-45 to DB-9 console cable
4-5.
78-17644-01