Implementing The Site-To-Site Scenario; Information To Have Available - Cisco ASA 5550 Series Getting Started Manual

Implementing the Site-to-Site Scenario

Figure 8-1 Network Layout for Site-to-Site VPN Configuration Scenario
Site A
Security
Appliance 1
Inside
10.10.10.0
Implementing the Site-to-Site Scenario

Information to Have Available

Cisco ASA 5550 Getting Started Guide
8-2
Outside
209.165.200.226
Creating a VPN site-to-site deployment such as the one in
to configure two adaptive security appliances, one on each side of the connection.
This section describes how to configure the adaptive security appliance in a
site-to-site VPN deployment, using example parameters from the remote-access
scenario shown in Figure
This section includes the following sections:
Information to Have Available, page 8-2
•
Configuring the Site-to-Site VPN, page 8-3
•
Before you begin the configuration procedure, gather the following information:
IP address of the remote adaptive security appliance peer
•
IP addresses of local hosts and networks permitted to use the tunnel to
•
communicate with resources on the remote site
IP addresses of remote hosts and networks permitted to use the tunnel to
•
communicate with local resources
Chapter 8
Outside
Internet
209.165.200.236
8-1.
Scenario: Site-to-Site VPN Configuration
Security
Appliance 2
Inside
10.20.20.0
Figure 8-1 requires you
Site B
78-17644-01