Solid-State Drive (Ssd); Gb 2280 Pcie3X4 Nvme Tlc L24339-001; Gb 2280 M2 Pcie3X4 Ssnvme Tlc L24340-001; Gb 2280 M2 Pcie3X4 Ssnvme Tlc L24341-001 - HP OMEN Maintenance And Service Manual

Solid-state drive (SSD)

Description
SSD
128 GB 2280 PCIe3x4 NVMe TLC
256 GB 2280 M2 PCIe3x4 SSNVMe TLC
512 GB 2280 M2 PCIe3x4 SSNVMe TLC
16 GB 2280 PCIe3x2 NVMe 3D X
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the base enclosure (see
Remove the solid-state drive:
1. Remove the Phillips M2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
NOTE:
Reverse this procedure to install the solid-state drive.
40 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Base enclosure on page
M.2 solid-state drives are designed with notches to prevent incorrect insertion.
Spare part number
L24339-001
L24340-001
L24341-001
L24342-001
35).