Solid-State Drive (Ssd) Board - HP 245 G8 Maintenance And Service Manual

4. To remove the hard drive connector, pull the connector (3) away from the hard drive.
Reverse this procedure to reassemble and install the hard drive.

Solid-state drive (SSD) board

To remove the SSD board, use this procedure and illustration.
Table 5-5 SSD board descriptions and part numbers
Description
SSD board
SSD bracket
SSD cable
Before removing the SSD board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove the SSD board:
1. Lift the ZIF connector (1), and then disconnect the cable (2) from the SSD board.
(Preparation for disassembly on page
Computer feet on page
Bottom cover on page
Battery on page 28).
26).
27).
Component replacement procedures
Spare part number
L24487-001
L24488-001
L23397-001
26).
31