Table of Contents
Advertisement
M.2 Solid-state drive (SSD) or eMMC module
Description
M.2 solid-state drive, 256 GB
M.2 solid-state drive, 128 GB
eMMC module, 128 GB
eMMC module, 64 GB
eMMC module, 32 GB
Before removing the solid-state drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2.
Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
48
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
Optical drive on page
Bottom cover on page
Solid-state drives are designed with notches to prevent incorrect insertion.
32).
33), if installed.
39).
Spare part number
865902-018
827560-049
833958-007
786461-013
779066-023
Advertisement
Table of Contents
