Power Button Board - HP OMEN Maintenance And Service Manual

Power button board

Description
Power button board
Before removing the power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the any smart cards and memory cards.
5. Remove the base enclosure (see
6. Remove the battery (see
7. Remove the hard drive (see
8. Remove the SSD (see
9. Remove the power connector cable (see
10. Remove the fans (see
11. Remove the system board (see
Remove the power button board:
1. Remove the two Phillips 3 mm screws (1) that secure the power button board.
2. Disconnect the power button board cable (2).
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Base enclosure on page
Battery on page 46).
Hard drive (HDD) on page
Solid-state drive (SSD) on page
Power connector cable on page
Fans on page 49).
System board on page
35).
38).
40).
52).
55).
Spare part number
L14374-001