Solid-State Drive (Ssd) - HP mt45 Maintenance And Service Manual

Solid-state drive (SSD)

Table 5-2 Solid-state drive description and part number
Description
128 GB, SATA-3, TLC
Solid-state drive shielding
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the drive to the system board.
2. Remove the drive by pulling it away from the connector (2).
IMPORTANT:
it on the replacement drive.
Reverse this procedure to install the solid-state drive.
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
(Preparation for disassembly on page
Bottom cover on page
When replacing the solid-state drive, remove the shielding from the old drive and install
32).
32).
Battery on page 44).
Spare part number
L62973-001
L68814-001