HP OMEN Maintenance And Service Manual page 66

8. Remove the SSD (see
9. Remove the power connector cable (see
10. Remove the fans (see
When replacing the system board, be sure to remove the following components (as applicable) from the
defective system board and install on the replacement system board:
● Heat sink (see
Remove the system board:
1. Make sure to disconnect the following cables from the system board:
(1) Drive cable
(2) Power connector cable
(3) Fan cable
(4) Display cable
(5) Fan cable
(6) Audio cable
(7) Speaker cable
(8) Smart card cable
(9) TouchPad cable
(10) Keyboard cable
(11) Backlight cable
NOTE:
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Solid-state drive (SSD) on page
Fans on page
Heat sink on page 58)
The fan cables were disconnected from the system board when the fans were removed.
40).
Power connector cable on page
49).
52).