Installing The Camera To The Mounting Cap - Bosch VEZ-400 Installation Manual

22 en | Installing a Pipe Mount
5.1.2

Installing the Camera to the Mounting Cap

To install the camera to the mounting cap, do the following:
1.
Figure 5.3 Location of parts of camera dome and mounting cap
2.
3.
F.01U.260.456 | 1.0 | 2011.10
Remove the dome cover from the camera by loosening the
three (3) dome cover mounting screws.
Align the camera base with the mounting cap, and mount
the base to the mounting cap using the four (4) mounting
screws supplied with the camera. In moist, wet, or outdoor
applications, make sure that all four mounting screws are
equipped with a rubber seal ring, and that they are
tightened fully to ensure protection against water ingress.
Mount the dome cover to the camera base. In moist, wet,
or outdoor applications, make sure that all three mounting
screws are equipped with a rubber seal ring, and that they
are tightened fully to ensure protection against water
ingress.
Installation Manual
Mini PTZ Dome Accessories
Bosch Security Systems, Inc.