Bosch VEZ-400 Installation Manual page 14

Mini PTZ Dome Accessories
Figure 4.4 Wall Mount Dimensions
2.
3.
4.
5.
6.
7.
8.
9.
Bosch Security Systems, Inc.
Use the four (4) holes at the end of the Wall Mount as a
template to mark the position where the holes should be
drilled to secure the mount.
Drill the four (4) holes in the installation location, screws
not supplied. Use a minimum screw length of 10 mm
(.39 in.).
Drill a fifth hole (maximum of 20 mm) in the center of the
four-hole pattern used to mount the arm.
Feed all wires from the camera through the arm using a
wire puller tool, and make the necessary connections.
In moist, wet, or outdoor applications, place the flat gasket
(item 1, below), between the surface and Wall Mount, and
make sure that the wires go through the gasket into the
wall.
Secure the mount using four (4) appropriate user-provided
fasteners such as Moly or Toggle bolts.
Attach the mounting cap to the arm. In moist, wet, or
outdoor applications, make sure that the thread on the
arm is sufficiently taped with Teflon tape before the
mounting cap is attached.
Skip to Section 4.1.3 Installing the Camera to the Mounting
Cap, page 16, to continue the installation.
Installation Manual
Installing a Wall Mount | en
F.01U.260.456 | 1.0 | 2011.10
15