Bosch VEZ-400 Installation Manual page 19

20 en | Installing a Pipe Mount
2.
3.
CAUTION!
All wires for installation applications must be routed through a
grounded conduit.
4.
5.
F.01U.260.456 | 1.0 | 2011.10
Use the four (4) holes in the flange as a template to mark
the position where the holes should be drilled to secure
the mount.
Drill the four (4) holes in the installation location. Use
screws (not supplied) with a minimum length of 10 mm
(.39 in.).
Drill a fifth hole (maximum of 20 mm [.79 in.]) in the
center of the four-hole pattern used to mount the flange.
Use this hole to feed the wires through the mount.
Fit the flange (supplied) to the pipe.
Note: Select the pipe length of 200 mm (7.9 in.), 300 mm
(11.8 in.), or combine the two (2) pipes with the integral
coupler for 505 mm (20 in.).
Apply the following couplings (supplied with the camera)
to the locations specified in the graphic below.
To ensure protection against water ingress, use the
supplied Teflon tape to seal the couplings.
Installation Manual
Mini PTZ Dome Accessories
Bosch Security Systems, Inc.