Table of Contents
Advertisement
8. Using Two Sigmas Together
Currently, the Delta Plugin and Sigma Remote support only one Sigma to be used at any time. However, there is still a way
to automate two Sigma's: One will be controlled/automated using Delta (MCU) and another by your DAW / Midi Absolute
(legacy mode).
If using two Sigmas, ensure that the following has been set up:
• Each Sigma has a different fixed IP address in the same range (eg. Sigma 1: 192.168.1.201, Sigma 2: 192.168.1.202) or,
if your switch is able to, use DHCP. All ip addresses will be automatically assigned to devices on the network when set to DHCP.
• Set Sigma 1 to Delta (MCU) control from the Sigma Remote application.
• Set Sigma 2 to another control protocol from the legacy web browser interface. More details on how to set this up can
be found in the legacy Sigma manual, available here:
If using a control surface for Sigma 1 via 'Delta(MCU)' control protocol, make sure that the ipMIDI ports set to control
Sigma 2 do not match those set for Sigma 1.
http://www2.solidstatelogic.com/studio/sigma/documents
Page 64
Advertisement
Table of Contents
Need help?
Do you have a question about the Sigma Delta and is the answer not in the manual?
Questions and answers