Software Installation And Configuration; Installing The Remote App - Solid State Logic Sigma Delta User Manual

3. Software Installation and Configuration

Sigma δelta requires the following software to be installed onto your computer:
• Sigma remote app – control of your Sigma δelta
• δ-Ctrl plugins – to automate Sigma; Single or 16 version as appropriate, δelta-Monitoring and δelta-Mix Bus
• ipMIDI software – Direct hardware control of Sigma from a compatible networked control surface using the MCU
(Mackie Control Unit) protocol – Only required if using a network-based control surface
• Nucleus remote – Only required if using an SSL Nucleus as a remote control surface
Locate either the SSL Delta Control.dmg disk image (Macintosh) or the SSL Delta Control Setup.zip file (Windows),
included as part of the Sigma downloads – these contain the Sigma Remote and ipMIDI applications, the plugin installer,
the Nucleus Remote profile and the latest version of the installation and operating instructions.
The files can be downloaded from the Update section of SSL's website here:
Please note: To access the Update section, the Sigma δelta unit must be registered to a
I r
NSTALLING THe
remote App (Mac)
Open the disk image and then the Sigma Remote Control.pkg;
follow the installation steps in the installer.
remote App (windows)
Open the zip file and run the SSL Sigma Remote.exe file;
follow the installation steps in the installer.
A
eMOTe PP
Update
Page 12
user account.