Solid State Logic Sigma Delta User Manual page 47

Cubase/Nuendo Session Setup
The Cubase/Nuendo Session Setup is identical to that on page 44. The control surface will send control messages directly
to the Sigma Remote app, which will then relay them to the Sigma hardware and -Ctrl plugin(s) (as shown in the diagram
below).
Tablet Sigma remote Setup
1. To connect a tablet running the Sigma Remote app, make sure that both your computer, Sigma and tablet are all
connected to the same wireless-enabled switch. (Please note that both Sigma and the computer must be connected
to the switch with Ethernet cables)
2. Boot the Sigma unit, and the Remote application on the computer.
3. Load the Sigma Remote app on the tablet. If it appears, click on the
refresh the connection between the tablet app and the computer app. You will now have control of the Sigma Remote
'Master' and 'Channels' sections on your tablet.
The Sigma Remote app must always be running on the computer for this setup to work correctly. Also, channel naming
is not available on the tablet version of the app; this must be done from the computer remote application.
symbol in the center of the screen; this will
Page 47