Power Up - Honeywell Searchline Excel Cross-Duct Technical Handbook

MAN0889_Issue 3_03/13
3. Installation and Operation

3.6.3 Power Up

(1) Apply power to the Searchline Excel Cross-Duct Transmitter and Receiver and Heated Reflector Panel
units.
(2) Press and hold the (Enter)
the unit.
Calibrator
Type SHC1
Z - SHC1 EXCEL
Interrogator
ESC
The Interrogator displays the following start-up message for approximately three seconds:
(3) Quickly check the type of connected detector shown on the top line of the message.
The display shows Excel or Optima+ or Optima.
(4) If the unit displays Optima+ or Optima immediately press the ESC key on the keypad.
The ESC key must be pressed within 3 seconds to have any effect. Also see Appendix A,
section 5.6.
This toggles the Interrogator mode between Excel, Optima Plus and Optima.
The start-up message is updated and displayed again for 3 seconds then the unit displays the
Main menu, which is the top level of its Interrogator's menu style interface, as follows:
The first line of the display shows the current level in the menu tree and the second line displays a sub-
menu title, action or data.
key on the Interrogator keypad for at least two seconds. This switches on
Note: Full details of the SHC1 Handheld Interrogator can be found in
Appendix A.
Z - SCH1 Excel
Interrogator 4V0
Main
Display v
24
Searchline Excel Cross-Duct Technical Handbook