Using The Code Hook; About The Hole Of The Atelier's Cabinet - Roland AT900 Music Atelier Owner's Manual

Before You Start Playing

Using the Code Hook

If you're using headphones or a mic, you can use the code
hook to neatly bundle the cables near your feet.
Attaching the Code Hook
1.
Screw the code hook (with wing nut) about
80% of the way into the screwhole located at
the bottom left of the organ.
2.
After you've oriented the hook as desired, use
the wing nut to fasten it.
Screwhole
Wing Nut
Code hook
26
About the Hole of the ATELIER's
Cabinet
AT-900
On the back of the AT-900 there are two holes through which
you can pass cables.
When connecting an external device to the AT-900, you can
pass the connection cables through these holes to the back.
1.
Remove the cap from the cable pass-thru
located on the back of the AT-900.
2.
Pass the cables through the holes from which
you removed the cover.
If you remove a cap, keep it in a safe place so that it is not
NOTE
lost.
fig.AT-900_RearBoard.eps
fig.00-31.eps
• Avoid inserting fingers into this hole.
AT-900C
On the back of the AT-900C there a hole through which you
can pass cables.
When connecting a DVD player or other external device to the
AT-900C, this allows you to organize the cables neatly.
1.
Remove the cover from the cable pass-through
located on the rear panel of the AT-900C.
Grasp the tab of the cable pass-through cover, and
remove the cover.